Infratech

 

 

Infrastructure Technologies, Inc.

Pipeline Repair Services...
 
 

Link-Pipe Grouting Sleeves

 
 

If its not broken, why fix it?  

  Check out Link-Pipe Grouting Sleeves.
 
Most sewers are less than 6% damaged.  Spot repair with Grouting Sleeves can save money and still completely restore the sewer to its original capacity.  An installation may take as little as 10 minutes.  Furthermore, estimates show that repair costs can be cut approximately 50% in comparing to the double tender system. Discuss your needs with Infratech.
Design and Manufacture of
No-Dig Pipe Repair Products Since 1980
 
 
LINK-PIPE offers Municipalities a new economic way to provide an improved level of service when maintaining their sewer systems.
The savings offered are based on switching from replacement and re-lining of the entire pipe to repair of only the damage by Spot Repair.  For this LINK-PIPE offers factory made high quality stainless steel and PVC sleeves.
The sleeves are easy to install and need very little equipment.
 

MASTERLINER Cured in Place Pipe  (CIPP)

 

Complete Pipelining Solutions for Today's Infrastructure  

 
Check out MASTERLINER.
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
Benefits of MASTERLINER’S Cured in Place Pipeline Rehabilitation Systems:
 
· No excavation
· Fast and simple installation
· High strength and corrosion resistant resins
· Very economical
· Joint-less renovation
· Full range of pipe sizes
· Custom pipe diameters and wall thickness
· Complete encapsulation system 
· Long term structural solution
· Improves flow characteristics
· Virtually eliminates infiltration & exfiltration
· Continuous research & development
· Quality assurance
· Inversion tubes, service lateral lining & spot repair liners
· Total Pipe renewal systems

Lateral Sealing

 
 
Lateral lines contribute to the expensive problem of groundwater infiltration.  On average, one-third of system infiltration enters through laterals.  Infratech can seal these laterals with polyurethane chemical grout.
 
                                         
 
                                               Lateral Packer by Logiball
 
 
 
Check out:   Logiball website

Tap Cutting & Cleaning Nozzles

 
Infratech can cut all your protruding taps using our Jet/Vac machines with an Intruder™ Tap Cutter mounted on the jetter hose.  The Intruder™ Tap Cutter is a low speed, high torque, impact cutter designed for more severe solid blockages.  It is basically a powerful hammer drill designed to run by hydraulic pressure off our 2000 psi Jet/Vac machine.  Its Hydro-Torque motor has three separate operating modes.
 
Check out:  NozzTeq®